Marshall DSL100HR 2-Channel Valve Head 100W (Black)

With the Marshall DSL100HR, the British rock'n'roll legend has given its most popular all-tube head a well-deserved makeover, adding useful details to the tried-and-tested two-channel design for use in the recording studio and rehearsal room. The EL34 power amp offers a power reduction, while the equalizer tuning has been revised. furthermore, an emulated Output with Softube speaker simulation is now available.

The preamp circuit of the Marshall DSL100HR is based on three ECC83 tubes and offers two channels. Classic Gain" and "Ultra Gain" each offer two sound modes that cover the entire spectrum of the typical Marshall sound. From the sparkling Clean and juicy Overdrive for Blues to the biting high gain for modern metal, the Marshall DSL 100 leaves no wish unfulfilled.

Both channels of the Marshall DSL100HR share a common 3-band tone control for adjusting the sound. A sensitive reworking has slimmed down the bass range, which is often perceived as too full, without losing any of its punch. With the help of the "Tone Shift" function, the midrange can also be adjusted, so that scooped sounds are also available for hard metal. Last but not least, the Presence and Resonance controls allow you to tune the bass and treble response in the power amp. The integrated reverb effect can be adjusted separately for both channels and convinces with a terrific spatiality.

The power amplifier of the Marshall DSL100HR is equipped with the usual EL34 tubes, which deliver 100 watts of power. Accordingly, adequate volume levels are available for the rehearsal room or the club stage. Thanks to the integrated power reduction, the head can also be played with 50 watts. This modulates the voltage and operating point of the tubes so that the typical sound character is preserved.

The Marshall DSL100HR is also equipped with an Emulated Line Out, which allows the guitar signal to be conveniently picked up both in the recording studio and on stage. The simulation of the classic Marshall 1960 Cabinet, developed in cooperation with the audio specialists at Softube, guarantees a particularly natural reproduction. The combined Line/mp3-In also allows playback of playbacks or backing tracks via the guitar amp.

• Two-channel all tube head for electric guitar
• 100 watts of power, reducible to 50 watts
• Preamp with three ECC83 tubes
• Power amp with two EL34 tubes and one ECC83 tube
• "Classic Gain" channel with clean and crunch mode as well as controls for gain and volume
• "Ultra Gain" channel with two overdrive modes and controls for gain and volume
• Common 3-band EQ for both channels with tone shift function
• Two Master volumes
• Integrated reverb effect with separate controls for each channel
• Serial FX loop with on/off switch
• Emulated Output with Softube simulation of a Marshall 1960 cabinet
• Silent recording capability (please refer to the manual!)
• Line/mp3 input
• MIDI In
• Speaker connections for guitar cabinets with 4 Ohm, 8 Ohm or 16 Ohm impedance
• Marshall PEDL-90012 footswitch included
• Compatible with the optional Marshall PEDL-91016 6-way footswitch (allows direct recall of all sound modes, changing Master volumes, and turning the effects loop on or off)